Area myBM
Username Password  
Non ricordi i tuoi dati?
Non hai un account? Crealo!
BanconoteMondiali.it
BanconoteMondiali.it
BanconoteMondiali.it
| | | | | |
 Tutti i forum
 Banconote
 Compro Banconote
 80KV 0.1HZ VLF High Voltage Generator

Note: E' necessario registarsi per rispondere.
Per registrarti clicca qui. Registrati è GRATIS!

Risoluzione schermo:
Username:
Password:
Modalità formato:
Formato: GrassettoCorsivoSottolineatoSbarrato Allinea a sinistraCentratoAllinea a destra Liena orizzontale Inserire linkInserire email Inserire codiceInserire QuoteInserire lista
   
Messaggio:

* HTML è disattivato
* Il codice nel forum è attivato
Smilies
Sorriso [:)] Sorriso grande [:D] Fico [8D] Timido [:I]
Risata [:P] Diavolo [):] Soldi [;)] Linguaccia [:o)]
Aiha [B)] Non ci credo [8] Triste [:(] Vittoria [8)]
Scioccato [:0] Arrabiato [:(!] Morto [xx(] Carino [|)]
Bacio [:X] Approvo [^] Disapprovo [V] Cosa? [?]

 
   

R E V I S I O N E    D I S C U S S I O N E
whgdmk12345 Postato il 12/02/2022 : 02:20:39
https://www.mktester.com/high-voltage-tester/vlf-hipot-tester/80kv-0-1hz-vlf-high-voltage-generator.htmlProducts Introduction#65306;

Ultra-low frequency dielectric strength testing is another method of power frequency withstand voltage testing, because large-capacity testing is required, and large-scale equipment is not only expensive, but also bulky. The power department did some tests to solve these problems. According to domestic and foreign tests, this product can solve this problem. Not only the size of the instrument is small, but the weight is greatly reduced.



Precautions#65306;

When carrying out 35KV cable test, one-phase test is strongly suggested. Voltage is set to 60KV (General Requirements)-78KV (according to the rules needed) and the frequency is set to 0.1Hz, 0.05Hz,0.02Hz and 0.01Hz. The manual said load capacity is the theoretical value, the scene 35KV cable length can reach 3-15 km.

In case the cable is too short(less than 500 meters), the capacitance of the test object is smaller than 0.1#956;F and the pressure cannot be normally boosted, please connect 0.1#956;F high-voltage capacitance in parallel way.

Keep high-voltage terminals nylon spin by the above numbers to the corresponding nylon seat, high-voltage lines to ensure good contact , no contact is good , it will cause a discharge , burned the high side . When nylon terminals tightened, pay attention to the intensity, excessive tightening may damage the nylon terminals.



80KV 0.1HZ VLF high voltage generator

Model

Rated Voltages

Load capacity

Fuse

Weight

Useful

VLF-80

80kV

(peak )

0.1Hz,#8804;0.5µF

25A

Control #65306;6#13199;

Body Boost I#65306;30#13199;

Body Boost II#65306;50#13199;

35KV and below the cable#12289;Generator

0.05Hz,#8804;1.0µF


0.02Hz,#8804;2.5µF


0.01Hz,#8804;5.0µF




Instrument Structure#65306;

1#12289;Control panel diagram


BanconoteMondiali.it © BanconoteMondiali.it Torna su
Powered By: Snitz Forums 2000 Version 3.4.07
Copyright © 2002-2010 Banconote Mondiali.it. All rights reserved.
Powered by Mattatore.it