-= Banconote Mondiali.it =- Forum delle banconote e monete

Area myBM

Username	Password

Non ricordi i tuoi dati? Non hai un account? Crealo!

BanconoteMondiali.it

BanconoteMondiali.it

Tutti i forum

Banconote

Discussioni Generali

Gravity cast intake manifold

Note: E' necessario registarsi per rispondere.
Per registrarti clicca qui. Registrati è GRATIS!

Risoluzione schermo:

Username:

Password:

Modalità formato:

Formato:

Messaggio:

* HTML è disattivato
* Il codice nel forum è attivato

Smilies

[quote][i]Originally posted by ovudapovytikenykozotevycyl[/i]
[br]Gravity cast intake manifold.For a carburetor or throttle type gasoline injection engine, the intake manifold refers to the inlet line after the carburetor or throttle body to the cylinder head inlet.Its function is to distribute air, fuel mixture by carburetor or throttle body to each cylinder inlet.The throttle body is a valve that controls how much the engine sucks in.It is a round piece of steel with a shaft in the middle, connected to and controlled by the throttle cable.The throttle body is a device on the engine intake system.The throttle body is generally divided into three parts: actuator, throttle plate and throttle position sensor, which are generally packaged as one.The water pipe on the side is the exhaust gas backflow to meet certain emission standards.Usually the valve body is made of aluminum, but there is also a small amount of plastic such as byd and so on.[hr][u]http://www.xinxingmachinery.com[/u]
[/quote]

Segna qui per includere la firma.

R E V I S I O N E D I S C U S S I O N E

ovudapovytikenykozotevycyl

Postato il 10/20/2020 : 21:21:16

Gravity cast intake manifold.For a carburetor or throttle type gasoline injection engine, the intake manifold refers to the inlet line after the carburetor or throttle body to the cylinder head inlet.Its function is to distribute air, fuel mixture by carburetor or throttle body to each cylinder inlet.The throttle body is a valve that controls how much the engine sucks in.It is a round piece of steel with a shaft in the middle, connected to and controlled by the throttle cable.The throttle body is a device on the engine intake system.The throttle body is generally divided into three parts: actuator, throttle plate and throttle position sensor, which are generally packaged as one.The water pipe on the side is the exhaust gas backflow to meet certain emission standards.Usually the valve body is made of aluminum, but there is also a small amount of plastic such as byd and so on.

http://www.xinxingmachinery.com

BanconoteMondiali.it